What do you need priced?
Wellpoint Prices South Africa vary mostly with one thing: how deep the water sits. Below are ballpark ranges for the whole job and its parts, so you can tell a fair quotation from an outlier before you commit.
Get real prices for your own property rather than a range.
Get the Best QuoteWhat You Are Actually Paying For
- Getting down. Jetting time and pipe, which is where depth shows up.
- The point itself. Casing and the slotted screen at the bottom.
- The pump. The single biggest item after the sinking on most jobs.
- Pipework. Trenching and pipe from the pump to where the water is used.
- Electrical. A plug point or a weatherproof isolator at the pump.
- Risk. The dry hole fee is how installers price the chance of no water.
Why Two Quotations Differ
- Depth included. One may quote nine metres and the other six.
- Pump quality. A budget jet pump and a cast iron one are years apart in life.
- Pipework scope. One price may stop at the pump and the other reach the garden.
- Development time. Cutting it short is invisible on the quote and costly later.
- Guarantee. On the point, on the pump, or on neither.
- Registration. Some include the municipal paperwork and some leave it to you.
Wellpoint Prices Prices
Ballpark South African wellpoint figures, by part of the job.
| Item | Ballpark price |
|---|---|
| Jetted point only, 6 to 9 metres | R3,500 - R7,500 |
| Point plus surface pump, fitted | R8,500 - R18,000 |
| Full install with tank and garden pipework | R15,000 - R35,000 |
| Surface jet pump, supplied and fitted | R3,200 - R11,000 |
| Pump controller or dry run switch | R950 - R3,800 |
| Iron filtration system, domestic | R6,500 - R22,000 |
| 5,000 litre tank, supplied and stood | R7,500 - R16,000 |
| Repair callout, first hour | R650 - R1,500 |
| Water test, laboratory | R850 - R3,200 |
Prices JUST UPDATED. Ballpark figures, rounded, excluding VAT. They reflect typical South African wellpoint, pump and water treatment rates. They are not our prices or quotations, and no provider is bound by them. Confirm what each quotation includes, such as travel, the depth allowed for, the dry hole fee, pipework and minimum callout fees.
Compare several quotations on the same brief.
Get the Best QuoteWhat Affects the Price
- Depth to water. The single largest factor in the sinking price.
- Ground conditions. Gravel and clay bands add hours.
- Pump specification. Flow rate, head and build quality all move the figure.
- Distance to the use point. Metres of trench and pipe, and labour to dig it.
- Storage. A tank and float valve change the pump and the plumbing.
- Province and travel. Callout rates differ and distance is charged.
What to Include in Your Request
- The address. Suburb and street; local ground sets the depth.
- What the water is for. Garden, pool, toilets or a business.
- Daily volume. Roughly, so the pump is sized rather than guessed at.
- Where the water must reach. In metres from the point.
- Whether you want storage. A tank changes the whole specification.
- What is already there. An old point, an existing pump or tank.
Reading a Wellpoint Quotation
- Check the depth it assumes. A cheap price for six metres is not a cheap price.
- Look for the dry hole fee. If it is not there, ask before signing.
- Separate point, pump and pipework. Three lines compare; one lump sum does not.
- Ask what the guarantee covers. Pump guarantees are usually the manufacturer's.
- Watch for VAT. Smaller installers often quote excluding it.
- Price the running cost too. A pump on for hours a day shows up on the bill.
Wellpoint Prices FAQs
What does a wellpoint cost in South Africa?
For the point alone, usually somewhere between R3,500 and R12,000 depending on depth. With a surface pump fitted and connected, most domestic installations land between R8,500 and R18,000. Adding a tank and garden pipework takes it towards R35,000.
Is a wellpoint cheaper than a borehole?
Considerably, because there is no rig and no rock drilling. A borehole is usually priced per metre and runs into tens of thousands before the pump. The trade-off is yield and reliability: a wellpoint gives less water and is more exposed to a dry season.
What do installers charge if they find no water?
Commonly R1,500 to R4,000, covering the trip and the jetting time. It varies a lot and some quote nothing for it at all, which is worth knowing before rather than after. Ask for the figure in writing on the quotation.
How much does it cost to run?
A typical domestic surface pump draws between 0.5 and 1.1 kilowatts. Running it two hours a day puts it in the region of 30 to 65 kilowatt hours a month, so the electricity is modest next to municipal water for the same volume.
Why is one quotation half the price of another?
Usually scope rather than greed. Check the depth each assumes, whether the pump is included and what grade it is, how far the pipework runs, and whether development and a yield test are in there. Put the same brief to both and the gap normally explains itself.
Prices vary by installer, which is what the providers listed on Wellpoint Installers SA are there to let you compare.
Related Services
Get the Best Quote, Fast
Client Reviews
Powered by leaderr
