When was it last serviced?
Wellpoint Maintenance South Africa is mostly about two things that creep up slowly: a screen that silts and a pump that is quietly working harder than it should. Both are cheap to deal with early and expensive to ignore. Compare servicing quotes per visit or per year.
Get servicing quotes for your point and pump.
Get the Best QuoteWhat a Service Covers
- Yield check. Litres an hour now, against what the point gave when new.
- Water level. Standing and pumping level, which shows how hard it is working.
- Strainer and filter. Cleaned or replaced, the most common neglected item.
- Valves. Foot valve and non return valve tested for holding.
- The pump. Current draw, noise, seal weep and bearing play.
- Electrical. Isolator, earthing and the state of the connections.
Redevelopment
- What it is. Surging and pumping hard to clear the screen and the sand around it.
- When it helps. Falling yield with the water table unchanged.
- How often. Every few years on most points, more on silty ground.
- What it recovers. Often most of the original yield.
- When it will not. A collapsed or corroded screen is past it.
Keeping It Going Between Visits
- Listen to the pump. A change in note usually comes before a failure.
- Clean the strainer. A few minutes, and it protects the impeller.
- Watch for sand. The first grit in the water is an early warning.
- Do not run it dry. One dry run can cost a mechanical seal.
- Rest it in winter. Less demand is a good time for the water table to recover.
- Keep it covered. Sun and rain age a surface pump faster than use does.
Wellpoint Maintenance Prices
Ballpark servicing figures so you can check a quotation.
| Item | Ballpark price |
|---|---|
| Annual service visit, point and pump | R850 - R2,400 |
| Yield test and written report | R450 - R1,200 |
| Strainer clean and filter change | R350 - R1,100 |
| Surge and redevelop the point | R1,800 - R5,500 |
| Pump service, seals and bearings | R1,400 - R4,500 |
| Annual arrangement, two visits | R1,600 - R4,500 |
| Valve replacement during a service | R650 - R2,200 |
Prices JUST UPDATED. Ballpark figures, rounded, excluding VAT. They reflect typical South African wellpoint, pump and water treatment rates. They are not our prices or quotations, and no provider is bound by them. Confirm what each quotation includes, such as travel, the depth allowed for, the dry hole fee, pipework and minimum callout fees.
Compare a one off service against an annual arrangement.
Get the Best QuoteWhat Affects the Price
- What is included. A yield check and a full pump service are different visits.
- Redevelopment. The largest single item when it is needed.
- Pump type. A cast iron unit takes longer to service than a plastic one.
- Access. A pump in a built housing adds time.
- Visit frequency. An annual arrangement is usually cheaper per visit.
- Travel. Distance from the installer's base.
What to Include in Your Request
- When it was last serviced. Or that it never has been.
- The original yield. From the installation, if you have it.
- What it gives now. Even roughly, in sprinkler terms.
- The pump make and rating. Off the plate on the body.
- Any symptoms. Sand, noise, pressure loss, tripping.
- How hard it works. Hours a day, and in which months.
Getting the Most From a Service
- Record the yield each time. The trend is what tells you the screen is going.
- Service before summer. Not in the middle of the season you need it.
- Ask for the water level figures. Standing and pumping, both.
- Fit protection if it is not there. A service visit is the cheapest time to add it.
- Keep the reports. They are what makes a repair quote arguable.
- Do not wait for failure. A silted screen caught early is a redevelopment, not a new point.
Wellpoint Maintenance FAQs
How often should a wellpoint be serviced?
Once a year suits most domestic points, timed before the season you use it hardest. Points in silty ground, or ones that run for hours a day, are worth looking at twice a year. The pump usually needs attention more often than the point does.
What is redevelopment and do I need it?
It is surging and pumping the point hard to clear the fine material that builds up in and around the screen. You need it when the yield has fallen while the water table has not. It often recovers most of the original flow for a fraction of a new installation.
My point gives less water than it used to. Is it failing?
Not necessarily. A falling water table, a silting screen and a tiring pump all look the same from the tap. Measuring the standing water level separates them. If the water is still there and the yield has dropped, redevelopment is usually the answer.
Can I service it myself?
You can clean the strainer, keep the pump covered and watch for sand and noise changes, and those alone prevent a lot of failures. Measuring water levels, redeveloping the point and anything inside the pump or on the electrical side wants someone with the gear and the sign off.
Does an annual arrangement save money?
Usually, per visit, and the bigger saving is in what does not break. The faults that cost the most, a dry run that takes out a seal and a screen left to silt up for years, are both the kind of thing a routine visit catches early.
Servicing arrangements are offered by providers listed on Wellpoint Installers SA alongside repairs and pump work.
Related Services
Get the Best Quote, Fast
Client Reviews
Powered by leaderr
